Brysbaert’s 2019 meta-analysis estimates average silent reading speed for adults reading English at 238 words per minute (WPM) for non-fiction and 260 WPM for fiction. The analysis pooled 190 studies and 18,573 participants. These figures describe groups of readers under study conditions. They are not a target, and they do not predict how fast you read.

Where the 238 WPM figure comes from

A single reading-rate study has a small sample, one set of texts and one way of timing people. Its result can sit well above or below the truth for reasons that have nothing to do with reading. A meta-analysis combines many such studies so that the quirks of each one matter less.

Brysbaert (2019) did this for reading rate and reported separate averages by kind of reading:

Kind of reading Average Typical range
Silent, English non-fiction 238 WPM about 175–300 WPM
Silent, English fiction 260 WPM about 200–320 WPM
Aloud (77 studies, 5,965 participants) 183 WPM not listed here

The “typical range” column matters as much as the average. A reader at 180 WPM and a reader at 295 WPM are both inside the normal span for non-fiction, yet the second finishes the same article in well under two thirds of the time.

Why the old 300 WPM figure was too high

For a long time, 300 WPM was repeated as the speed of an average adult. Brysbaert (2019) points out that this is higher than the pooled evidence supports.

It is easy to see how a number like that travels. Carver (1992), for example, put ordinary reading at roughly 300 WPM, but his estimates describe college students, who read a great deal and are not a cross-section of adults. A figure that is reasonable for one practised group turns into a general “average” once the qualifier is dropped. That is our reading of how the number spread, not a finding of either paper.

The gap is large enough to change plans. For a 2,000-word article:

  • at 300 WPM the estimate is 6 min 40 sec
  • at 238 WPM it is 8 min 24 sec

That is 1 min 44 sec more, or about 26% longer. Over an 80,000-word book the same gap is 4 hr 27 min against 5 hr 36 min, a difference of more than an hour. Budgeting at 300 WPM for a general audience can therefore leave too little time for many readers.

Why fiction is read faster than non-fiction

The 22 WPM gap between fiction and non-fiction does not mean stories are read carelessly. Brysbaert (2019) attributes most of it to word length: non-fiction uses longer words.

This is partly an artefact of the unit. WPM counts “cat” and “characterisation” as one word each, although the second takes more of the eye’s and the mind’s time. Eye-movement research has long shown that readers spend longer on less frequent words (Just & Carpenter, 1980), and informational writing is full of them. A text made of short, common words therefore produces a higher WPM figure even when the reader is working at the same effort.

For a planning example, an 80,000-word novel at 260 WPM takes 5 hr 8 min, and an 80,000-word non-fiction book at 238 WPM takes 5 hr 36 min. The 28-minute difference follows from using the two group averages. It does not predict the difference for a particular reader or pair of books.

What kind of average this is

Three limits are built into the number.

It describes adults reading English. The studies behind it measured adult readers of English. It says nothing direct about children, about people reading in a second language, or about other languages.

It describes study conditions. Participants know they are being measured. They read a set text, usually a fairly short one, in a quiet setting, often with questions to follow. Reading at home with a phone nearby, or reading the fortieth page of a report late in the afternoon, is a different situation.

It describes reading for understanding. The figure is for people actually reading the text, not scanning it for a name or skimming for the gist. Those are legitimate activities with much higher rates, and they should not be compared with 238.

How much individual readers vary

The typical range for non-fiction, about 175 to 300 WPM, already covers a wide spread of ordinary adults. For 1,000 words, that spread looks like this:

  • 180 WPM: 5 min 33 sec
  • 238 WPM: 4 min 12 sec
  • 300 WPM: 3 min 20 sec

The same person also varies. Carver (1992) describes reading as a set of different processes, from scanning to memorising, each with its own typical rate, and a reader moves between them depending on the task. Add the effect of the text itself and one person’s rate can easily shift by tens of words per minute within a day. Our guide to how text difficulty changes reading speed covers that in detail.

So there is no single “your reading speed” hidden behind the average. There is a rate for a given text, purpose and state of attention.

Other languages are not covered

The 238 and 260 figures should not be carried over to other languages. Trauzettel-Klosinski & Dietz (2012) developed standardised passages in 17 languages and had people read them aloud; the measured rates in words per minute differed from language to language and between texts within a language.

Part of the reason is the unit again. What counts as a word is a convention that changes across writing systems (Unicode Standard Annex #29). As a matter of arithmetic, a language that builds long compound words will show fewer words per minute for the same content than a language that spreads the content over many short words, without anyone reading more slowly in any meaningful sense. A WPM value only makes sense alongside the language and the kind of text it was measured on.

What to do with the number

Use it as a default for other people. If you are estimating reading time for an audience you cannot measure, such as blog readers or the recipients of a report, 238 WPM is a defensible middle value for English non-fiction. It is the default in the reading time calculator, and our explanation of how reading time is calculated shows the arithmetic behind the result.

Show a range when the stakes are higher. For a 2,500-word briefing, 238 WPM gives 10 min 30 sec, but 180 WPM gives 13 min 53 sec. If people must finish before a meeting, plan for the slower figure.

Replace it with your own figure for your own reading. The average is a poor stand-in for one person. Take the reading speed test to get a measured rate with a comprehension check, and follow the steps for finding a personal baseline so that one unusual attempt does not mislead you.

Do not treat it as a grade. Reading below 238 WPM is not a failure and reading above it is not an achievement. Whether a speed is good depends on what you needed from the text, which is the subject of our guide to what counts as a good reading speed.

Use 183 WPM, not 238, for reading aloud. Speaking the words is slower than reading them silently. A 1,000-word piece that takes 4 min 12 sec to read silently takes about 5 min 28 sec to read aloud at the average oral rate.

The honest summary of 238 WPM is short: it is a well-supported average for English-speaking adults reading non-fiction silently in research settings. It is the right starting assumption when you know nothing about the reader, and the wrong one as soon as you know something.